Heat Exchanger suction line Accumulator model has
been developed for use on low temperature system to sub cool liquid line which
also features a boil out coil. They are meant solely to boil oft excessive liquid refrigerant in the bottom of
accumulator by passing the liquid line through the heat exchanger coil. This increases system efficiency while helping to raise the oil temperature to facilitate oil flow in the suction line for befter flow, while the system is running.
By using the liquid line through the coil the liquid line is sub cooled whenever cold suction liquid has flooded the accumulator. This regains most of the system efficiency
lost due to incomplete boiling in the evaporator when no liquid was present and
very little beat transfer took place, as the coil was at the bottom of the
vessel. To this effect, beat exchange
accumulators are mostly used on low temperature system or where frequent flood
back may be a problem.
Models can be
developed as per OEMS design and specification.
